Vertical Xcelerator IP Guida Utente Scaricare il pdf (Pagina 18)

2-6 Assembling the IP Phone

Chapter 2 - Install & Connect the Phone

Xcelerator IP User Guide March 2007

Connecting the Cables

To avoid any problems caused by power-on, the power source will be applied to the

phone last. Do not plug the adaptor head to the wall socket if you are using Power

adaptor. Do not plug the Ethernet cable to the uplink switch if you are using PoE.

Prepare the Ethernet cable(s), attached in the package, and power adaptor (no need for

PoE user). Plug the cable(s) to their corresponding ports on the back of the IP phone. It is

recommended that you set the stand angle at a 60º angle so that room is sufficient for

easy access to connect the cables. Arrange the cables to go under the big U-type frame

as shown in the illustration.

Full Connection Example

The following illustration is an example of a full connection.

(1) To Handset thru curled cord, (2) to IP Network thru Ethernet cable, (3) to PC/

Notebook thru Ethernet cable, (4) to wall socket thru Power adaptor, and (to use

Headset, plug the headset with R-J9 plug to the Headset jack on the left bottom of the IP

phone) (5) to headset thru headset cable.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 63 64

Nessun commento

Vertical Xcelerator IP Guida Utente Pagina 18